Protect your Investment

The main reason for a bad investment is misinformation or little knowledge; this is why we explain the simple difference you should know before investing in your pool table:

REAL SLATE POOL TABLE

Our pool tables

  FAKE NON-SLATE POOL TABLE

Others companies

VS

Buying a Pool Table, especially a real "slate pool table" is not a simple as you might think.  There are over 1,200 manufacturers of Slate Pool Tables in the world today, and hundreds of other companies that make pool tables with fake slate beds.  Here are some Frequently Asked Questions to get you started:

 

 Q:  "Do I really need a Slate Pool Table or Should I get a "Slate" or Non-Slate Table?"

A:  That depends, do you care if the balls roll straight when you hit them with the pool cue?  Slate is the only play surface material that can be precision leveled to 1/10,000 of an inch so that the pool balls roll in a straight line on every shot.  If you don't care if the balls roll straight, then save yourself some money and buy a "toy" table (non-slate).

 

Q:  "Is all Three Piece Slate Pretty Much the same?"

A:  An obvious difference is thickness.  Three piece slate pool tables with less than 1" Thick Slate are much lighter and more likely to go out of level over time.  The biggest difference is how the slate is cut.  Slate is mined out of the ground, cut into 3 pieces, sanded or "honed" flat, then backed with a wood or MDF Frame.  Slate that has too high or too low a moisture content is prone to cracking and chipping.  Many companies improperly "hone" the slate, using small 6" sanding disks instead of the 5 foot wide sanding disks required to properly flatten slate.  You can actually see the sanding marks on improperly honed slate going back and forth over and over again, watch out!  All properly honed slate is also a matched set, three pieces cut from one original.  There is always a Simi-circle chalk mark on the slate that should line up perfectly when the table is being assembled.  This is how you can tell you have a "matched set" of pool table slate.  Also, some companies use very cheap material to "Frame" or "Back" their slate.  Good slate backing should be durable and not chip, flake off, or warp, so that the bed cloth (felt) can be replaced over and over again*.

 

*If you have more questions or concerns.